49 lines
1.9 KiB
Plaintext
49 lines
1.9 KiB
Plaintext
The best source of recent information is the Arduino forum
|
|
|
|
http://arduino.cc/forum/
|
|
|
|
Also search the Adafruit forum
|
|
|
|
http://forums.adafruit.com/
|
|
|
|
If you are using a Teensy try
|
|
|
|
http://forum.pjrc.com/forum.php
|
|
|
|
Try running the SdInfo sketch in the SdFat/examples folder to get
|
|
more information.
|
|
|
|
|
|
The most common problems are:
|
|
|
|
--------------------------------------------------------------------------------
|
|
Wiring errors with card.init() failure and errorCode == 1. This means the
|
|
first command, CMD0 - SPI init, failed. SdFat is not seeing the card.
|
|
This is a basic hardware problem. Do not reformat your SD.
|
|
--------------------------------------------------------------------------------
|
|
card.init() failures caused by resistor SPI level shifters. Some, mostly older,
|
|
SD cards work with resistor level shifters but may be flaky with random errors.
|
|
|
|
Many newer SD cards have edge detectors and fail with errorCode() = 1. These
|
|
cards will not work with resistor level shifters since SdFat does not see the
|
|
card at low SPI clock rate.
|
|
|
|
Other cards fail with an errorCode() > 1. These cards see SD commands at low
|
|
SPI clock rate but fail at higher SPI clock rate. It may be possible to use
|
|
these cards by replacing card.init() with card.init(SPI_HALF_SPEED).
|
|
This will slow the the SPI clock by 50%.
|
|
|
|
--------------------------------------------------------------------------------
|
|
Redefining SS_PIN to be a pin other than the Arduino/AVR hardware SS pin.
|
|
|
|
Arduino/AVR SPI will only function correctly in master mode if the hardware SS
|
|
pin is in output mode. Sd2Card::init() will enable output mode for the hardware
|
|
SS pin even if it is not SD chip select.
|
|
|
|
If you have multiple SPI devices you must insure devices other than the SD card
|
|
have their chip select pin high when Sd2Card::init() is called.
|
|
|
|
If you want to understand in more detail how AVR SPI works read this
|
|
|
|
http://www.atmel.com/dyn/resources/prod_documents/doc2585.pdf. See section 2.3.
|