60 lines
2.4 KiB
Plaintext
60 lines
2.4 KiB
Plaintext
This is a demo of a data logging sketch that is capable of logging serial
|
|
data to an SD card at up to 115200 baud.
|
|
|
|
You must install the SdFat library to use the SerialPortLogger. SdFat
|
|
can be downloaded from:
|
|
|
|
http://code.google.com/p/sdfatlib/downloads/list
|
|
|
|
Normally the maximum rate for a 328 Arduino is 57600 baud.
|
|
|
|
It is possible to log data at 115200 baud with a 328 Arduino if you use a high
|
|
quality SD card.
|
|
|
|
Lower quality cards can have an occasional write latency of over 100
|
|
milliseconds. This will cause a receive data overrun at 115200 baud since
|
|
the RX buffer on a 328 Arduino is 1024 bytes. You need to reduce the baud
|
|
rate to 57600 if your SD card causes receive overruns.
|
|
|
|
Most SD cards will work with a Mega Arduino at 115200 baud since the RX
|
|
buffer is set to 4096 bytes.
|
|
|
|
It is possible to use software SPI on a Mega by setting MEGA_SOFT_SPI nonzero
|
|
in SdFatConfig.h. This will allow a shield like the Adafruit Data Logging
|
|
shield to be used on a Mega without jumper wires.
|
|
|
|
The two programs, SerialPortLogger.ino and SerialDataSource.ino, demonstrate
|
|
high speed logging of serial data.
|
|
|
|
To run this demo, you need two Arduino boards and an SD shield or SD module.
|
|
|
|
The board with the SD shield should have an LED and series resistor connected
|
|
from pin 3 to ground. This LED will blink an error code if an error occurs.
|
|
|
|
Make sure BAUD_RATE has the same value in SerialPortLogger.ino and
|
|
SerialDataSource.ino.
|
|
|
|
Load SerialPortLogger.ino into the board with an SD shield or module and
|
|
SerialDataSource.ino into the second board.
|
|
|
|
Connect a wire between GND pins on the two boards.
|
|
|
|
Connect a wire between the serial RX pin (Pin 0) on the SD board and the
|
|
serial TX pin (pin 1) on the data source board.
|
|
|
|
It is best to power the two boards with an external 9V supply.
|
|
|
|
After the boards are powered up, wait until the pin 13 LED on the data source
|
|
board goes out. This will take up to 50 seconds.
|
|
|
|
Insert an SD into the logger board. press reset on the logger board. The
|
|
error LED connected to pin 3 should not light.
|
|
|
|
Press reset on the data source board. The pin 13 LED on the data source
|
|
board should light for about 50 seconds at 57600 baud or 25 seconds at
|
|
115200 baud while 280,000 bytes are transferred.
|
|
|
|
If an error occurs, the error LED on the SD board will flash an error code.
|
|
See the SerialPortLogger.ino source for definitions of error codes.
|
|
|
|
Remove the SD and check the file SERIAL.BIN. In this case it is a text file. |