keyboard/qmk/lib/ugfx/boards/base/STM32F746-Discovery/example_raw32/openocd.cfg

95 lines
2.1 KiB
INI
Raw Normal View History

# This is a script file for OpenOCD ?.?.?
#
# It is set up for the STM32F749-Discovery board using the ST-Link JTAG adaptor.
#
# Assuming the current directory is your project directory containing this openocd.cfg file...
#
# To program your device:
#
# openocd -f openocd.cfg -c "Burn yourfile.bin" -c shutdown
#
# To debug your device:
#
# openocd
# (This will run openocd in gdb server debug mode. Leave it running in the background)
#
# gdb yourfile.elf
# (To start gdb. Then run the following commands in gdb...)
#
# target remote 127.0.0.1:3333
# monitor Debug
# stepi
# (This last stepi resynchronizes gdb).
#
# If you want to reprogram from within gdb:
#
# monitor Burn yourfile.bin
#
echo ""
echo "##### Loading debugger..."
source [find interface/stlink-v2-1.cfg]
echo ""
echo "##### Loading CPU..."
source [find target/stm32f7x.cfg]
echo ""
echo "##### Configuring..."
#reset_config srst_only srst_nogate
#cortex_m maskisr (auto|on|off)
#cortex_m vector_catch [all|none|list]
#cortex_m reset_config (srst|sysresetreq|vectreset)
#gdb_breakpoint_override hard
proc Debug { } {
echo ""
echo "##### Debug Session Connected..."
reset init
echo "Ready..."
}
proc Burn {file} {
echo ""
echo "##### Burning $file to device..."
halt
# Due to an issue with the combination of the ST-Link adapters and OpenOCD
# applying the stm32f2x unlock 0 command actaully applies read protection - VERY BAD!
# If this happens to you - use the ST-Link utility to set the option byte back to normal.
# If you are using a different debugger eg a FT2232 based adapter you can uncomment the line below.
#stm32f2x unlock 0
#flash protect 0 0 last off
reset halt
flash write_image erase $file 0 elf
verify_image $file 0x0 elf
#flash protect 0 0 last on
reset
echo "Burning Complete!"
}
echo ""
echo "##### Leaving Configuration Mode..."
init
reset init
flash probe 0
flash banks
#flash info 0
echo ""
echo "##### Waiting for debug connections..."
##### OLD ######
#source [find interface/stlink-v2-1.cfg]
#source [find target/stm32f7x.cfg]
#
#proc flash_chip {} {
# halt
# reset halt
# flash write_image erase main.elf 0 elf
# verify_image main.elf 0 elf
# reset
# shutdown
#}
#
#init